How to Measure Your Windows

Casement windows can consist of one or two separate window panels that crank open. The window panels either open outwards to the side (as shown above) or open outwards and up. In any of these cases, the entire window opening must be guarded.

 

Follow the Step by Step Instructions Below to Properly Guard Your Casement Windows
For technical assistance, contact safe-tots.com at (508)757-0820

 
1)  Measure the height and width inside of the window frame. 
      (Figure 3-1)

 
2) Measure the depth of the window frame where the posts will be mounted (Inside top and bottom of window frame).
  • If there are shades, blinds, etc. mounted in the frame that may interfere with the guard or if the depth of the window frame measures less than 3/4 inches, the guard will need to be mounted on the outside of the window frame (on the window trim or wall). Add at least 1-1/2 inches to the inside window frame height measurement. The extra 1-1/2 inches is the width of both end posts.

 
3) Once you have determined the above measurements, you can request sizing and pricing information by clicking here.
  • Simply fill out our Sizing Request Form and we will e-mail you with the correct guard(s) for your window and pricing.

 

4) Once you receive your window guard, install it following the included instructions.

 

Cautionary Note
There should be no more than a 4-inch opening anywhere in the guarded area.
(See illustrations below)

 

The above illustration shows a casement window guarded with two 5-bar guards, mounted side by side

  1. Large bar (5/8" diameter)
  2. Small bar (1/2" diameter)
  3. End post, screws into top of window frame or molding from bottom or front (4 screws per guard)
  4. Grid assembly, vertical bars telescope to fit various heights
  5. Do not install guard more than 2 inches from edge of frame
  6. Each end post is 3/4" wide x 3/4" deep
  7. Emergency release button (each guard has 4)
  8. End post screws into bottom of window frame or molding from top or front (4 screws per guard)

Important Safety Notes

     ·Before installing, verify building and fire codes are not being violated. Contact local
      building code or fire department for specific codes.
     ·Screws should be anchored firmly into a solid stud or frame material to achieve
      maximum safety.
     ·This window guard is intended to protect against potential window falls by children
      age 5 & under.
     ·Parents, child-care custodians and older children must understand the proper 
      operation of this guard in case of emergency.
     ·Window guards are designed to be a deterrent against accidental window falls. This
      product is not intended as a substitute for proper adult supervision.
     ·Guardian Angel Window Guards are not meant to protect against intruders.


Possible Fall Hazard

Young children may fall out of the window if the window guard is not installed correctly.
     ·Check to make sure there are no openings in the guarded area more than 4 inches.
Young children may fall out of the window if installation instructions are not followed.
     ·Use recommended materials and techniques.
     ·Make sure window guard is securely attached to the window frame.
     ·Make sure the window frame is in good condition.

Download Measuring Instructions


Value Packages - Get More For Less!
Our exclusive Value Packages give you more of what you need while saving you money. Check out our special packages designed for

· Newborns & Infants
· Toddlers

Did You Know...??
Accidents are the number one health hazard faced by children.

To help parents become aware of some common safety hazards around the home, we have put together a Safety Tips and Information Guide. You can view and download this guide by clicking the link below.

Safety Tips & Information Guide

 

 

© 2008 safe-tots.com /  All Rights Reserved